Board index Flathead Power-Technical Questions, Answers, and Suggestions Pans 63’ outside oiler heads on 48’ lower end?

63’ outside oiler heads on 48’ lower end?


Posts: 164
Location: athens,greece
Hello again,
Haven’t been on here in a while.. since i sold my 2 UL’s..
I recently acquired a 1948 FL motor, basically the lower end…
I have a set of 63’ outside oiler heads, and was wondering
If I can run these without too much modification?
When I got the motor it was running 70’s shovelheads and lifterblocks…
Any info is greatly appreciated..
Thank you…

Posts: 3540
Location: Central Illinois, USA
A Knuckle cam cover would be the easiest way, Yp!

If it was running Shovels, it has probably already been set up to feed the heads.


Return to Pans