Board index Flathead Power-Technical Questions, Answers, and Suggestions Shovels Clutch problems

Clutch problems

Post Tue Sep 29, 2020 10:32 pm

Posts: 1
Here is a picture of what came out of my clutch. I recently acquired a 1975 FLH and the clutch was dragging real bad. I tried to adjust it by the book but it didn't help. I took the clutch apart today and 8 of the 10 springs were broken. Can anyone tell me what would cause something like this to happen and do I need to look for something other than the replacement springs? The friction and steel plates look fairly new.
clutch springs.jpg
clutch springs.jpg (126.29 KiB) Viewed 85 times

Post Wed Sep 30, 2020 3:30 pm
Pa Site Admin

Posts: 6223
Location: Ohio USA

Check the support bearing behind the primary cover.

Post Wed Sep 30, 2020 5:03 pm
don

Posts: 594
Location: Spokane WA USA
Those Springs, Might be suffering from Hydrogen Embrittlement. They appear to be plated. May be? The source of springs, Did Not bake them after plating!
I never use Hidden Plated Springs, Expecially on Clutch Plates. Any good Spring Shop will form a good set for You.


Return to Shovels