Board index Flathead Power-Technical Questions, Answers, and Suggestions Knuckles Right Side Engine Mount Nut and Washers?

Right Side Engine Mount Nut and Washers?

Post Mon Jun 04, 2018 7:15 pm

Posts: 32
Location: Northern Michigan USA
I'm putting my Frankenstein Knucklehead in a Panhead frame and have a question about the front right side engind mount nut and washers. The original set up used only a standard bolt and washer but now I have what I believe is the correct bolt, spacer and washer but I'm not sure of the lock washer placement. Does it go on the bottom between the frame and the tab is bent over the head of the bolt?
You do not have the required permissions to view the files attached to this post.

Posts: 3429
Location: Central Illinois, USA
Sorry nobody replied, Zeek!

Your guess seems logical, although its hard to imagine it does that much.

Indian did that in several places, but there was always a dimple (in the sprocket or whatever) for a punch to lock the other part of the washer.


Return to Knuckles