Cams ground

I have a set of indian scout cam blanks (completely round) both are one-piece with their respective gear.

Does anyone have a source to grind them? Jim Mosher does lobes, but no means to handle blanks still affixed to gears.

I would think they need machined before ground, then hardened, then finish ground. Pa

That may well be the case Pa. My machining knowledge is limited.

I do know that I have cams (blanks) and gears that have approximately 1" lift, 360 degree duration...
I am thinking if used in their current state performance may suffer just a tad if both valves are held open infinitely.

I have a lightening cam and it needs brought back to life..can somebody recomended a shop?

I had some cams for my KHK done by Weber many years ago. The quality was great and the motor liked them.

It won't be cheap , but I would imagine they have grinds for the Indian and Lightning in their files.
They won't be listed on the site...you'll have to call them. Might be worth your time and dime.

http://www.webcamshafts.com/index_blank ... earch.html

not sure where u r or if the need still exists.. . .try this guy. . .

http://www.leinewebercams.com/ he is in Southern California.


put his cams in my 45" Servicar. made it usable on the freeways in So Cal.

[Dusty-Dave]

For anybody that just wants lobes for their Indian. http://www.ebay.com/itm/Indian-Cam-Lobe ... 2291551665
Eveything I've got from them seems to be top notch.
Dusty

Senor, Dusty thanks for the link..

Dusty-Dave wrote:

For anybody that just wants lobes for their Indian. http://www.ebay.com/itm/Indian-Cam-Lobe ... 2291551665
Eveything I've got from them seems to be top notch.
Dusty